anyone make sense of these stats?

[colinwarren]

Just wanted a concensus of what this means and if there are any issues that can be addressed,

Max package only 3mb capacity of line,


System Up Time 01:55:36
Port Status TxPkts RxPkts Collisions Tx B/s Rx B/s Up Time
WAN PPPoA 3 3 0 7 2 00:00:25
LAN 10M/100M 2577 0 0 32 0 01:55:33
WLAN 11M/54M 65067 59436 0 9403 2669 01:55:26

ADSL Link Downstream Upstream
Connection Speed 1718 kbps 201 kbps
Line Attenuation 52.0 db 32.8 db
Noise Margin 7.3 db 9.0 db

[colinwarren]

sorry here are my detailed stats


gone, below are stats from test socket

[PaulSky]

Have you been capped for errors? I take it you are on your main socket, everything filtered correctly, no extensions in use.

[colinwarren]

No not been capped as far as i know, filters in place and mastersocket used.
To be honest using extension, normal faceplate and even master socket makes no difference to line speed, have tried everything to tweak speed.

[IWasNotTheEnemy]

can you post stats from master socket so we can be the judge of it...

[richone54]

Mode: ADSL2
Channel: Fast
Trellis: U:ON /D:ON
Line Status: No Defect
Training Status: Showtime
Down Up
SNR (dB): 7.3 9.0
Attn(dB): 52.0 32.8
Pwr(dBm): 0.0 12.8
Max(Kbps): 1544 268
Rate (Kbps): 1718 201

odd, your connected higher than your max rate. you may wand to post a set of stats form the "Test" socket

[colinwarren]

Here are latest stats,ethernet cabled to master socket,

ppp0 Link encap:Point-Point Protocol
inet addr:90.203.157.248 P-t-P:82.108.11.74 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1500 Metric:1
RX packets:3079 errors:0 dropped:0 overruns:0 frame:0
TX packets:2814 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:3
RX bytes:2963442 (2.8 MiB) TX bytes:461480 (450.6 KiB)

Uptime 730.62 711.91
Wan up 89.49 77.67
adslctl: ADSL driver and PHY status
Status: ShowtimeRetrain Reason: 0
Channel: FAST, Upstream rate = 201 Kbps, Downstream rate = 1911 Kbps
Link Power State: L0
Mode: ADSL2
Channel: Fast
Trellis: U:ON /D:ON
Line Status: No Defect
Training Status: Showtime
Down Up
SNR (dB): 4.9 10.0
Attn(dB): 52.0 32.7
Pwr(dBm): 0.4 12.8
Max(Kbps): 1512 268
Rate (Kbps): 1911 201
G.dmt framing
K: 59(0) 7
R: 16 16
S: 4 16
D: 32 4
ADSL2 framing
MSGc: 60 68
B: 58 6
M: 4 16
T: 1 1
R: 16 16
S: 3.8843 15.2835
L: 519 67
D: 32 4
Counters
SF: 44191 41595
SFErr: 0 1
RS: 729158 184559
RSCorr: 8214 0
RSUnCorr: 0 0

HEC: 0 0
OCD: 0 0
LCD: 0 0
Total Cells: 3189810 335677
Data Cells: 64196 12632
Drop Cells: 0
Bit Errors: 0 0

ES: 0 1
SES: 0 0
UAS: 15 178
AS: 708

INP: 3.94 3.82
PER: 16.02 17.67
delay: 31.07 15.28
OR: 32.95 33.50

Bitswap: 226 13

Total time = 12 min 10 sec
SF = 44191
CRC = 0
LOS = 0
LOF = 0
ES = 0
Latest 1 day time = 12 min 10 sec
SF = 44191
CRC = 0
LOS = 0
LOF = 0
ES = 0
Latest 15 minutes time = 12 min 10 sec
SF = 44191
CRC = 0
LOS = 0
LOF = 0
ES = 0
Previous 15 minutes time = 0 sec
SF = 0
CRC = 0
LOS = 0
LOF = 0
ES = 0
Previous 1 day time = 0 sec
SF = 0
CRC = 0
LOS = 0
LOF = 0
ES = 0
Showtime Drop Reason: 0
Last Retrain Reason: 0




Uploads are chronic and downloads sometimes remind me of old dialup from the 90's.
BT master socket,wiring then going to a small box on inside wall, which has connections between master socket wiring and box and cabling through wall to a BT wall box that feeds other residents in block
hope this helps you guys out

[IWasNotTheEnemy]

i assume you don't have a test socke then? if not, chances are the 'box' between outside line and master socket is the cause of the issues...

[colinwarren]

yes faceplate is off and wired into test socket, i assume the connection box between master socket and outside is BT property, can this be argued, that this is causing loss of speed?

[richone54]

Mode: ADSL2
Channel: Fast
Trellis: U:ON /D:ON
Line Status: No Defect
Training Status: Showtime
Down Up
SNR (dB): 4.9 10.0
Attn(dB): 52.0 32.7
Pwr(dBm): 0.4 12.8
Max(Kbps): 1512 268
Rate (Kbps): 1911 201

your stats are still very strange, not sure if it has anything to do with DLM ?, if dlm was not being done i would have suggested you speak to sky about your set up (the old addage used to be, attennuation over about 40db would only be put on GDMT, not sure what it is now)