As requested here is an idiots guide to flashing your router. Same disclaimer applies as in the OP.
Thanks to vishal and markbloke for coming up with the ideas.
This guide only applies to the White Netgear DG834GT V1 Router. For information regarding the Black V2 Netgear DG934G Router click here, for information regarding the Black V2 Sagem F@ST 2504 click here.
Recovery Utility: http://kbserver.netgear.com/release_notes/d102417.asp
Firmware (1.02.04): http://kbserver.netgear.com/release_notes/D102796.asp
Firmware (Version 1.02.09): http://kbserver.netgear.com/release_notes/D103145.asp
Download the recovery utility and unzip it.
Download the latest firmware and save it to the same directory as the extracted Recovery Utility.
It should look like this (it is very important that the firmware is saved here):
Have just one PC connected via a LAN cable.
Logon to your router and click on
Backup Settings
Save the
netgear.cfg file and keep it safe:
Power down the router.
Using a pen or something small keep the reset button on the back pressed whilst turning on the router.
I held it down for about 3-4 seconds. Holding it down too long might erase your settings.
You will now see the Power and Test light flash in an alternating way:
Browse to the DG834 Recovery Utility directory and run RmDrv.exe
Then run
UpgradeWizard.exe
Click next
Select your network card (thats connected to the router)
If sucessful a device (and only one) will be listed here, select and click next:
It will start the upgrade process and will tell you once complete.
Basic Settings
You will see your username but your password is masked:
To get your password click Backup Settings and save the CFG file. Open the CFG file in Wordpad.
# Netgear DG834GT Text Format Configure File v0.2
#
# FW Version V1.02.04
#
# Usage:
# # value list or syntax
# [index]"variable"=value
#< Wizard >
# English German Italian French
[10001]"Language"=English
# Australia France Italy Singapore Sweden Switzerland UK Other
[10002]"Country"=UK
#< Basic Settings >
# dhcpc pppoe pppoa ipoa bridge ip
[20001]"WAN protocol"=pppoa
# 0:off 1:on
[20002]"NAT (Network Address Translation)"=1
#< PPPoE >
[20101]"Login"=
[20102]"Password"=
[20103]"Service Name"=
[20104]"Idle Timeout"=0
[20105]"Static IP Address"=
#< PPPoA >
[20201]"Login"=
006969DD6969@skydsl
[20202]"Password"=
6f1da1f81f
[20203]"Idle Timeout"=0
[20204]"Static IP Address"=
Disclaimer: Skyuser.co.uk makes this tutorial available for your reference only. Please do not try this, and if you do attempt to do so, is at your own risk. We cannot accept any responsibilities for any killing of Netgear routers.
