.
.
Note: DO NOT use the method described in this thread to get your username and password - a "safer" method rather than flashing the FW is now available and can be found here.
.
.
.
.
.
Before reading this thread Please read this first.
With all credit to
James67
This tutorial only applies to a Black Netgear V2 Sky DG934G Router
Download the unofficial updated Firmware at your own risk
DG934G-1SKUKS_V2.02.34-telnet.img
And save to your desktop or a location of your choice.
Go to your browser and type in
http://192.168.0.1 then using your username and password, which is usually
admin and
sky, log into the router.
1. Select Router Upgrade
2. Click Browse and then look for the file you just downloaded and select it
3. Once selected, click on Upload
4. Do not turn your router off or touch until it completes the process
Once this has finished and you have reconnected on your Sky Broadband connection, open a Command Prompt and type the following:
1.
Telnet 192.168.0.1 then hit enter
2. Type
cat /tmp/password.txt then hit enter
And once again, this procedure is completely untested and it may render your router useless. Do NOT do it unless you know what you're doing and are not dependent on the router. You HAVE been WARNED!
SkyUser make this information available in the interests of our members. Please do not upgrade your FW unless you fully understand the risks that it could go wrong and render your router useless. Please remember also, that it is against the Terms and Conditions of Sky Broadband. You also run a high risk of having your Broadband Connection suspended as well as receiving no Technical Support.
From this thread
DG934G Source Code
Linear Mode
